Antenna Connection

Figure 7

Antenna Placement with Accessory Brackets and Cables

If possible, do not mount the brackets on a wall. See Figure 7 for bracket and antenna placement.

Attach the two antenna cables to the back of the USR-100. Be sure the connectors are tightened securely. Route the cable to the antennas and attach in the same manner.

-16-

Page 19

Image 19

Telex USR-100 operating instructions Antenna Placement with Accessory Brackets and Cables, Antenna Connection

Contents

Telex Table of Contents Table of Contents General Information Antennas Posi Phase DiversityComputer Controlled Channels Audio PowerDisplays Audio Output USR-100 Receiver Specifications Model SH-100 Transmitter Specifications Model LT-100 Transmitter Specifications Front Panel Rear Panel Antenna Mounting Receiver Set-up Bottom View SH-100 Set-Up Battery Meter Top View Side View Back View LT-100 Microphone Connector wired as follows Set-Up System Set-Up Antenna Placement Bracket Mounting Antenna Connection Antenna Placement with Accessory Brackets and Cables Assembly of Rack Mount Installing Rack Mounts Double Mounting Model AB-2 Combination Antenna Bracket Model CLA-X 1/2 Wave Antenna Model ALP-450 450-900 MHz Directional Log Periodic Antenna Front Connector Mounting KitOrder No FCC Information Customer Service Information June

Telex USR-100 Antenna Placement with Accessory Brackets and Cables, Antenna Connection

Models: USR-100

Antenna Placement with Accessory Brackets and Cables

Antenna Connection