Telular SX3e user manual Amps Technician Programming Commands, Press # * 0 * 1 2 3 4 4 3 2 1 #

AMPS Technician Programming

IMPORTANT!

The following commands may be used by a trained service technician to change the configuration of the Phonecell SX3. WARNING: these commands are intended for use by trained service technicians only. Untrained users could

!damage the Phonecell, violate local regulations and breach the service agree- ment with the cellular provider. For further assistance, please contact

your Authorized Telular Representative.

AMPS Technician Programming Commands

The Phonecell SX3 can be programmed on location with an ordinary telephone, which is sometimes referred to as a POTS (Plain Old Telephone Set) phone.

NOTE: the Technician Programming mode is not accessible while in a call.

In the following sections, an <entered value> is comprised of the digits 0 through 9. The digits '*' and '#' are considered invalid when used inside an <entered value>, and will cause that command/value to be rejected.

When you enter the programming mode, a timer is started. If there are no key entries within any 2-minute period, the FWT will revert to its normal mode. Going on-hook (hanging up the phone) will exit the programming mode.

How to Enter the Technician Programming Mode

Use the following access code to enter the Programming mode:

Press: ￿ # * 0 * 1 2 3 4 4 3 2 1 #

The access code is 8 digits. If the access code is not 8 digits or does not match the stored access code, the Technician Programming mode cannot be not entered. This code is pre-programmed during production and cannot be changed in the field.

If you enter the access code correctly, the dial tone should change to a different, steady “Programming” tone and the LED indicator on the front of the Phonecell will blink alternately RED and GREEN to indicate that you’re in the programming mode.

PHONECELL SX3e AMPS 22 USER MANUAL