![](/images/new-backgrounds/1034999/3499917x1.webp)
Step 3. NAM/Phone Number Setup
|
| IMPORTANT! |
|
| |
| ! | If your Phonecell was NOT |
| Assignment Module/Phone Number) information, follow the | |
|
| steps below. Otherwise, continue to STEP 4 – pages |
|
|
|
You can program the Phonecell SX3 with an ordinary
Step #1 - Pick up the POTS handset and listen for a tone (either a steady dial tone or a beeping
Step #2 - Enter the
Step #3 -
Step #4 -
# * 0 * 1 2 3 4 4 3 2 1 #
The dial tone should change to a different, steady “Programming” tone and the LED indicator on the front of your Phonecell should blink alternately RED and GREEN to indicate that you’re now in the programming mode. You now have two minutes to begin the programming steps below.
Press:
The spaces represent your
Press:
The spaces represent your 1- to
NOTE: depending upon whether you enter an odd SID or an even SID, the Phonecell will automatically set the remaining NAM parameters to AMPS standards – as shown in the table below.
Automatically Set NAM Parameters
Initial Dedicated Control Channel
First Paging Channel
Number of Dedicated Control Channels
Preferred System
Roam Option (to override, see page 23)
AMPS Standards
Odd SID | Even SID |
333 | 334 |
333 | 334 |
21 | 21 |
A | B |
Enabled | Enabled |
If you need to override any of the settings, continue with the following steps
PHONECELL SX3e AMPS | 9 |