Connect Your SX4e to AC Power
1)A protective earth (safety ground) terminal (screw) marked with this protective earth symbol is provided on the back of the SX4e Phonecell unit. Connect this terminal to a good earth ground (i.e., a cold water pipe) by means of an 18 gauge or heavier insu- lated wire. The wire insulation should be green with a yellow stripe to indicate that this is a protective earth (safety ground) connection - see Figure 5.
2)Connect the Line Cord from the AC power source to the Power Supply.
Protective earth (safety ground) terminal screw
Figure 5 - Protective earth terminal screw.
3)Connect the barrel plug on the Power Supply to the Power Input port marked “DC Input”, on the side of the SX4e.
NOTE: An optional battery back up unit (not supplied) may be used instead of the Power Supply - see Figure 6. Follow the battery installation instructions provided with the Backup Unit.
4)The LED Power Status indicator (located on the front of the FWT) will turn green immediately upon connecting to power.
Power “DC
INPUT” Port
Optional Battery
Backup Unit
Power
Supply
Line Cord
Figure 6 - Connect the SX4e to power.
●
●
AC Power
SX4e TDMA 800 • SX4e | 5 | Technical Manual |
