Antenna Assembly (continued)
Antenna Assembly (continued)
TV36
5
5. Find the large antenna section and remove the nut and bolt. Slide the narrow boom into the larger section. Tap lightly with a rubber mallet on the end of the small boom aligning the bolt holes. (See figure 4.)
NOTE: Make sure that the side of the small boom with the phasing lines line up with the nuts on the large boom.
Fig. 4
6.Remove the nuts and washers from the first element holder studs of the large section on the bottom of the antenna. (See figure 5.) Place the phasing lines from the front section over the studs, and
Phasing Lines
Fig. 5
TV36
6
7. Loosen the nuts on the downlead connections. Attach the transformer ends to the studs, between the washers, and tighten the nuts securely. (See figure 6.) Attach the coax downlead to the transformer.
Fig. 6
Transformer
Downlead
Connections
