![Figure 9: Virtual serial port in Windows Device manager](/images/new-backgrounds/123202/12320223x1.webp)
CC2511 Dongle
When Windows have finished installing the device, a new serial port will appear in the device manager in Windows. See Figure 9.
Figure 9: Virtual serial port in Windows Device manager
The Windows driver will only work if the “Ti Wireless USB to Serial” is assigned to COM1 to COM9. (In Figure 9 it is assigned to COM6)
If there are many COM ports installed on the PC, Windows may chose to assign it to a number higher than 9. If that happens it must be changed. Right click on the “Ti Wireless USB to Serial” in the device manager and choose “Properties”
6.2.3Running the application
Connect the CC2510EM to the SmartRF04EB and power it. Use the joystick and the S1 button to select the settings for the UART. The settings can only be selected once, if they are wrong, turn power off and on to reset the CC2510EM and select UART settings again.
These settings only apply to the UART on the CC2510/SmartRF04EB, the settings used on the Virtual COM port on the PC can be different.
Changing the settings on the CC2510EM/SmartRF04EB will not affect the settings used in the Virtual COM port and visa versa.
To bind the CC2510EM to the CC2511 Dongle, hold them close together and push S1 on the SmartRF04EB. The RF protocol found in the CC2511 firmware library uses
To test the link connect a RS232 cable between a PC and the SmartRF04EB, start HyperTerminal in Windows (Start
Connect one HyperTerminal window to the Virtual COM port, and another HyperTerminal window to the COM port connected to the CC2510EM/SmartRF04EB.
Text written to one window will be sent to the other one.
SWRU082 | Page 12 of 24 |