Texas Instruments DAC7741EVM manual 5. Jumper Setting Function Continued

Jumper Setting

Table 3-5. Jumper Setting Function (Continued)

Reference	Jumper		Function
	Setting
			Disconnects AGND from DGND.
W11			Connects AGND and DGND together.
	1	3	Positive supply rail of op-amp is powered by +15V.
W12	1	3	Positive supply rail of op-amp is powered by VCC.
	2	4 6	Routes the raw output of the DAC7741 to J4-2 and J5 output terminals.
	1	3 5
	2	4 6	Routes the output of U2 to J4-2 and J5 output terminals. Used for unipolar and bipolar
W13			modes of operation.
	1	3 5
	2	4 6	Routes the output of U2 to J4-2 and J5 output terminals. Used for capacitive load
			driving.

1 3 5

Disconnects exREFin from the negative input terminal of U2.

W14	Allows exREFin to be routed to the negative input terminal of U2 used for
	experimentation purposes only.
W15	Disconnect the negative terminal of U2 to AGND and disable 2x gain.
	Configures U2 for a 2⋅ gain output.
	RSTSEL pin is pulled high and configures the DAC to midscale when POR or reset is
W16	initiated.
	RSTSEL pin is pulled low and configures the DAC to minscale when POR or reset is
	initiated.
		pin is pulled high and configures the DAC not to reset (default state).
	RST

W17

RST pin is pulled low and holds the DAC to reset state.

Legend:

Indicates the corresponding pins that are shorted or closed.

3-6