Texas Instruments SLOU082 manual Quick Start, JP1 JP2 JP3 JP4 JP5 JP6 JP7 JP8

Chapter 2

Quick Start

Follow the steps in this chapter to quickly prepare the TPA032D03 mono class-D audio amplifier EVM for use. Using the TPA032D03 class-D EVM with the TI plug-n-play audio amplifier evaluation platform is a quick and easy way to connect power, signal and control inputs, and signal outputs to the EVM using standard connectors. However, the audio amplifier evaluation module can be used stand-alone by making connections directly to the module pins, and it can be wired directly into existing circuits or equipment.

The platform switch and jumper settings shown in Table 2±1 are typical for the TPA032D03 class-D EVM. There are no jumpers or switches to set on the TPA032D03 class-D EVM board, itself.

Table 2±1. Typical TI Plug-N-Play Platform Jumper and Switch Settings for the TPA032D03 Class-D EVM

POWER TYPE (Note 2)	JP1	JP2	JP3	JP4	JP5	JP6	JP7	JP8	S1	S2 (Note 3)	S3
VCC (J1)	ON	OFF	OFF	ON	ON	Mute	X	Lo	ON	OFF	U5
AC/DC (J2)	OFF	ON	OFF	ON	ON	Mute	X	Lo	ON	OFF	U5

Notes: 1) ON = Jumper installed, OFF = Jumper NOT Installed, X = Don't care

2)Install a voltage regulator EVM (SLVP097) in platform socket U6 for VDD power to EVM control inputs.

3)Set to ON when Tone Control Board SLOP109 is installed in U1, otherwise set to OFF.

Topic		Page
2.1	Precautions	. . 2±2
2.2	Quick Start List for Platform	. . 2±3
2.3	Quick Start List for Stand-Alone	. . 2±5

2-1