![](/images/new-backgrounds/1020002/2000213x1.webp)
www.ti.com |
3Quick-Setup Guide
This section describes the TAS5102/3EVM board in regards to power supplies and system interfaces. It provides information regarding handling and unpacking, absolute operating conditions, and a description of the factory default switch and jumper configuration.
The section also provides a
3.1Electrostatic Discharge Warning
Many components on the TAS5102/3EVM are susceptible to damage by electrostatic discharge (ESD). Customers are advised to observe proper ESD handling precautions when unpacking and handling the EVM, including the use of a grounded wrist strap at an approved ESD workstation.
CAUTION
Failure to observe ESD handling procedures can result in damage to EVM components.
3.2Unpacking the EVM
On opening the
∙1 pc. TAS5102/3 EVM Power Stage Board
∙1 pc.
∙Because this system has standard connectors, no cables are supplied
∙1 pc. TAS5102/3EVM
If any of these items are missing, contact the Texas Instruments Product Information Center nearest you to inquire about a replacement.
Connect the Modulator/Input board to the Power Stage board with the docking connectors on each board. Use care because this connector is not keyed.
Figure 2. Modulator and Power Stage Board Connection Example
3.3Power Supply Setup
To power up the EVM, one power supply is needed for system power, logic and
TAS5102EVM and TAS5103EVM for the TAS5102 and TAS5103 Digital Amplifier Power Output Stages | 7 |