Application Report
SLLA032
Board Layout and Configuration
The TNETE2201 EVM kit is designed to give the developer many options for operation. Many of these options are selectable by DIP switch and others may require board component removal or additions. The following sections provide guidelines to configure the EVM kit for different modes of operation.
The EVM kit is normally delivered in a default configuration that requires external clock and data inputs. The
Table 1. Default Setup as Shipped
Designator | Function | Condition (TNETE2201) |
P5 | CLK SEL | Jumper installed between Pins 2 and 3 |
R1 | TX Termination | 200 ohm installed |
R2 | TX Termination | 200 ohm installed |
R5 | Bias Net | 365 ohm installed |
R6 | Bias Net | 562 ohm installed |
R8 | WIZ OPTION | Not installed |
R9 | WIZ OPTION | Not installed |
R16 | CAP OPTION | Zero ohm installed |
R17 | Bias Net | Not installed |
R21 | WIZ OPTION | Not installed |
R22 | WIZ OPTION | Not installed |
C13 | Vcc Decouple | 0.01 µF installed |
C23 | GBIC OPTION | Not installed |
C24 | SMA OPTION | 0.01 µF installed |
C25 | GBIC OPTION | Not installed |
C26 | SMA OPTION | 0.01 µF installed |
C27 | SMA OPTION | 0.01 µF installed |
C28 | GBIC OPTION | Not installed |
C29 | GBIC OPTION | Not installed |
C30 | SMA OPTION | 0.01 µF installed |
C31 | RX Termination | 0.01 µF installed |
C32 | TX PLL Cap | 0.0022 µF installed |
C33 | REF CLK Bias Net | Zero 0hm installed |
C34 | TX PLL Cap | 0.0022 µF installed |
L1 | Filter/Bias | Ferrite installed |
X1 | OSC | Not installed (not provided) |
PRBSEN | X (OFF) | |
TXRRAMP | X (OFF) | |
TXDIR | X (OFF) |
TNETE2201 EVM Kit Setup and Usage | 3 |