Texas Instruments TPA6030A4 manual Quick Start List for Stand-Alone, Quick Start Module Map

Quick Start List for Stand-Alone

2.3 Quick Start List for Stand-Alone

Follow these steps to use the TPA6030A4EVM stand-alone or when connecting it to existing circuits or equipment. Connections to the TPA6030A4 module header pins can be made via individual sockets, wire-wrapping, or soldering to the pins, either on the top or the bottom of the module circuit board. Numbered callouts for selected steps are shown in Figure 2–3.

Figure 2–3. Quick Start Module Map

86

7

-Power Supply

1)Ensure that all external power sources are set to OFF.

2)Connect an external regulated power supply set from 7 V to 15 V to the module VCC and GND pins taking care to observe marked polarity.

-Inputs and Outputs

3)Ensure that audio signal source level adjustments are set to minimum.

4)Connect the right (or left) positive lead of the audio source to the module

R LINE+ (or L LINE+) pins and the negative lead to the R LINE– (or L LINE–) pins. If using the headphone inputs, connect the positive audio source to the module R HP+ (L HP+) and the negative lead to R HP– (L HP–).The inputs can be used with a differential or single-ended audio source. If stereo use is desired, connect both right and left inputs to the appropriate sources.

5)Select output mode:

a)For BTL output, connect a speaker to the module OUT+ and OUT– pins of each channel, (see Figure 2–4)

or

b)For single-ended output, connect a headphone or a speaker to the module OUT+ and GND pins of each channel through a 33 ∝ F to 1000 ∝ F output-coupling capacitor (Figure 2–5).

2-6 Quick Start