BASE AND TOE PANEL (Continued)
CA
B |
D
Figure 29
DWHD94BP and DWHD94BS Base and Toe Panel Installation
1.Place the Base Part under and up the front bottom panel of the dishwasher, as shown in Figure 29.
2.Insert the Base Part screws (Figure 1, letter O) into the Base Part, as shown in Figure 29, letter B. Tighten the Base Part Screws.
3.Place the Cotton Insulation Strip (Figure 1, letter C) under the unit, between the bottom of the Base Part and the floor, as shown in Figure 29, letter C.
4.Place the toe panel over the Cotton Insulation Strip, and use the toe panel screws (Figure 1, letter N) to secure the toe panel in place, as shown in Figure 29, letter D.
FINAL INSTRUCTIONS
1.Energize the dishwasher power supply circuit.
2.Consult the Dishwasher Use and Care Manual, and run the dishwasher through one complete cycle.
If the dishwasher does not operate properly, refer to the
15
