DISHWASHER PREPARATION (continued)
B
A
Figure 12
Junction
Box Cover
Figure 13
Removing the Toe Panel
DWHD94BF Regular Toe Panel
The toe panel is loosely attached with tape. Remove the tape and pull the toe panel away from the dishwasher. Set the toe panel aside. It will be reinstalled later.
DWHD94BP and DWHD94BS Base and Toe Panel
The base and toe panel are in place on the dishwasher, but are not attached. Remove the toe panel first, as shown in Figure 12, letter A, then remove the base, as shown in Figure 12, letter B.
Installing the 90° Elbow Fitting
NOTE: The 90° elbow fitting is not supplied with the dishwasher, and must be purchased separately. If the dishwasher’s hot water supply line is to be copper tubing, make certain the elbow has a compression fitting.
Apply Teflon tape or other pipe sealant when required.
Orient the hot water supply connection leg of the elbow toward the channel opening in the dishwasher base.
Junction Box Preparation
1.Remove junction box cover, Figure 13, by lifting the junction box cover up and off.
2.Remove the strain relief plate by removing the screw at the back of the junction box, as shown in Figure 14, letter D and sliding the strain relief plate out.
3.Set the junction box cover, strain relief plate, and screw aside. They will be
Junction Box |
D |
Figure 14
8