Cycle Completion Signal
This feature is a tone that sounds when your dishwasher finishes washing and drying your dishes. You can either disable the tone, or you can set it at one of two volumes (the dishwasher leaves our factory with the tone set on the lowest volume).
To change the Cycle Completion Signal Volume:
1.Open the dishwasher door far enough to expose the control buttons.
2.Press and hold down the right- most of the two buttons labelled “Cancel Drain”, as shown in Figure 34, then press and hold the On/Off button. When the light on the “Cancel Drain” button you are pressing illuminates, and the tone begins to sound, release both buttons.
3.Press the “Cancel Drain” button you previously pressed until the tone is at the desired volume, or until it is silent.
4.Press the On/Off Button.
5.Close the dishwasher door. The Cycle Completion Signal is now set, and you may wash your dishes as usual.
Unloading Your Dishwasher
Dishware tends to be hot
immediately after washing and drying. To cool your dishware more quickly, open the dishwasher door slightly for a few minutes before unloading.
Always unload the lower rack first and unload the upper rack last. This will prevent any residual water on the upper rack from dripping onto the dishes in the lower rack, as shown in Figure 26.
Figure 26
The silverware basket(s) can be easily removed for unloading by simply lifting it out of the rack.
Rack Features and
Accessories
In addition to the accessories discussed in this manual, you can find many more at our website, www.thermador.com.
Flip Tines
Flip Tines fold down to make loading the racks easier in some instances.
To operate the Flip Tines, simply grasp the tines and gently fold them downward.
Cup Shelves
Grasp the Cup Shelves, as shown in Figure 27, and fold them down. Place cups
Figure 27
Knife Rack
The Knife Rack, shown in Figure 28, may be used for a variety of purposes, but it is primarily designed to hold fine silverware and cutlery.
The Knife Rack may be removed by gently pulling it from the two clips that attach it to the rack.
Figure 28
Rack Attachment
When installed on the back of the lower rack, as shown in Figure 29, the Rack Attachment serves a variety of uses such as holding cups, large knives, spatulas, or other large utensils.
Install the Rack Attachment by gently levering it into position along the back of the lower rack until it is held in place as shown by Figure 29 A.
Figure 29
A
CARE AND
MAINTENANCE
Certain areas of your dishwasher
require occasional maintenance. The maintenance tasks are easy to do and will ensure continued superior performance from your dishwasher.
(Continued on next page)
10