SAFETY INSTRUCTIONS
Read All Instructions Before Using the Appliance.
READ AND SAVE THESE INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
A.Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including
B.Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent back- drafting. Follow the heating equip- ment manufacturer’s guideline and safety standards such as those published by the National Fired Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.
C.When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
D.Ducted fans must always be vented to the outdoors.
E.Always unplug or disconnect the appliance from the power supply before servicing.
F.This unit is designed for indoor use only. Use this unit only in the manner intended by the manufacturer.
WARNING
For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors.
To reduce risk of fire and to properly exhaust air, be sure to duct air outside. Do not vent exhaust air into spaces within walls, ceilings, attics, crawl spaces or garages.
TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCT WORK.
To reduce the risk of fire or electric shock, do not use the fan with any solid- state speed control device.
This appliance has been found to be in compliance with UL 507 Standard for Electric Fans and
Parts Needed
❑Tape Measure
❑Phillips Head Screwdriver
❑Duct Tape
❑Ductwork (configuration varies depending on location; see ”Prior to installation”).
❑Additional Sheetmetal screws
(as necessary for ductwork installation)
Parts Supplied
❑Appliance assembly (1)
❑Sheetmetal Screws (6)
❑Wood Screws (4)
❑Counter Sink Screws (2)
❑Hardware for brackets on vent (2)
❑Plugs UX6 (6)
3
