IMPORTANT SAFETY INSTRUCTIONS
Read All Instructions Before Using the Appliance.
READ AND SAVE THESE INSTRUCTIONS.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOW- ING:
A.Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire- related construction.
B.Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent backdrafting.
Follow the heating equipment manufacturer’s guideline and safety standards such as those pub- lished by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.
C.When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
D.Ducted fans must always be vented to the out- doors.
E.Always unplug or disconnect the appliance from the power supply before servicing.
F.This unit is designed for indoor use only.
Use this unit only in the manner intended by the manufacturer.
This unit is manufactured for indoor use only. Do not use this unit outdoors.
WARNING
Caution: For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors.
To reduce risk of fire and to properly exhaust air, be sure to duct air outside. Do not vent exhaust air into spaces within walls, ceilings, attics, crawl spaces or garages.
TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.
To reduce the risk of fire or electric shock, do not use the fan with any
This appliance has been found to be in compliance with UL507 Standard for Electric Fans and
It is the responsibility of the owner and the installer to determine if additional requirements or standards apply in specific installations.
To reduce the risk of fire and electrical shock, install this rangehood only with blowers manufactured by BSH see page 2.
Tools Needed | Parts Included |
❑ Tape measure | ❑ Appliance assembly (1) |
❑ Philips screwdriver | ❑ Wood screws (4) |
❑ Duct tape | ❑ Metrical screws M5x45 (4) |
❑ Ductwork (configuration varies depending on location) | ❑ Hardware for mounting brackets (2) |
❑ Additional sheet metal screws (as necessary for | ❑ Plugs UX6 (4) |
ductwork installation) |
|
PAGE 1
