BEFORE INSTALLING HOOD
Discharge Direction: The hood is shipped ready for horizontal discharge. To change to vertical discharge move plate to the rear side and ventilator (if supplied) to the top side.
The plate and ventilator are held in place by four nuts each, see also Figures 3 and ,at page 9, Figure A and Figure B.
Read also paragraph “Integral Ventilator Installation” at pages
Assembly of the Transition: The transition supplied with the hood mounts to the top of the hood, Figure 4.
1.Fold outwards all six Tabs (HS and HSB series only).
2.Align mounting holes at base of transition with mounting holes on 1/2” flange located at the top of the hood.
3.Fasten transition to hood using 6 (4 mm x 9.5 mm) screws (included with hood).
4.Duct tape connection between transition and hood.
5.Remove tape holding damper
Plate
Figure 3
Transition
Top outlet
plate fixing point
Tab
Figure 4
Page 10
