CAUTION
If burner does not light, turn knobs to OFF , wait 5 minutes, and try again. If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidently ignite with risk of injury.
Match-Lighting
Do not lean over grill while lighting.
1. Open lid. Turn on gas at LP tank.
2.Place lit match into match lighting hole beneath grill bottom as shown below.
3. | Push in and turn RIGHT knob to | (Ignite). Be sure burner | |
| lights and stays lit. |
|
|
4. | Light left burner by turning LEFT knob to | (Ignite). | |
Ignitor Lighting The Sideburner
Do not lean over grill while lighting.
1. Turn gas on at LP tank..
2. Push in and turn sideburner knob to High.
3.Push ignitor button rapidly (up to 5 times) to light. Be sure burner lights and stays lit.
4.If burner does not light, turn knob to OFF, wait 5 minutes, then try again or use match.
Match Lighting
1.Turn on gas at LP tank.
2.Place lit match near burner.
3.Push in and turn sideburner knob to High. Be sure burner lights and stays lit.
Before Your First Cookout
•Light burners, check to make sure they are lit, then close the lid and warm up grill on 
(High) for 15 minutes. Curing of paint and parts will produce an odor only on first lighting. Do not
warm up grill with knobs on 
(Ignite). Knobs and handle may
become uncomfortably hot if knobs are left on
(Ignite).
Burner Flame Check
•Remove cooking grate and VapoRISER Bar. Light burner, rotate knobs from 
(High) to 
(Low). You should see a smaller flame in Low position than seen on High. Always check flame prior to each use. Perform flame check on sideburner. If only low flame is seen refer to "Sudden drop or low flame" in the Troubleshooting Section.
High
Low
Turning Grill Off
•Turn all knobs to OFF position. Turn LP tank off by turning
Ignitor Check
•Turn gas off at LP tank. Press ignitor button rapidly. "Click" should be heard and spark seen each time between collector box or burner and electrodes. See "Troubleshooting" if no click or spark.
Valve Check
•Important: Make sure gas is off at LP tank before checking valves. Knobs lock in OFF position. To check valves, first push in knobs and release, knobs should spring back. If knobs do not spring back, replace valve assembly before using grill. Turn knobs to Low position then turn back to OFF position. Valves should turn smoothly.
Hose Check
•Before each use, check to see if hoses are cut or worn. Replace damaged hoses before using grill. Use only valve/hose/regulator specified by manufacturer.
General Grill Cleaning
•Do not mistake brown or black accumulation of grease and smoke for paint. Interiors of gas grills are not painted at the factory (and should never be painted). Apply a strong solution of detergent and water or use a grill cleaner with scrub brush on insides of grill lid and bottom. Rinse and allow to completely air dry. Do not apply a caustic grill/oven cleaner to painted surfaces.
•Plastic parts: Wash with warm soapy water and wipe dry.
Do not use citrisol, abrasive cleaners, degreasers or a concentrated grill cleaner on plastic parts. Damage to and failure of parts can result.
•Porcelain surfaces: Because of
•Painted surfaces: Wash with mild detergent or nonabrasive cleaner and warm soapy water. Wipe dry with a soft nonabrasive cloth.
8 • 461644604
