Thiel Audio Products SS2 manual Feet, Thiel, SmartSub

Feet

The subwoofer is supplied with four pointed, screw-in feet that can be used to provide firmer coupling to the floor for slightly better sound quality and to prevent the unit from moving during use. Please be advised that their use can put

dents in hardwood floors. They are screwed into the bottom of the unit, and should be individually adjusted until the unit is firmly seated onto the floor without rocking. Then tighten each of the back-nuts to lock the feet in place.

THIEL

SmartSub®

Patents Pending

WARNING

TO PREVENT FIRE OR SHOCK HAZARD

DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE

NO USER SERVICEABLE PARTS INSIDE

REFER SERVICING TO QUALIFIED PERSONNEL

REPLACE FUSE ONLY WITH SAME RATING

CAUTION	!
RISK OF ELECTRIC SHOCK
DO NOT OPEN

AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR

ATTENTION

POUR EVITER TOUS RISQUES DE FEU OU DE CHOC ELECTRIQUE

N'EXPOSEZ PAS CET APPAREIL A L'HUMIDITE

AUCUN COMPOSANT NE PEUT ETRE REMPLACE PAR L'UTILISATEUR

VEULLEZ CONTACTER LE SERVICE APRES VENTE AGREE

REMPLACER LE FUSIBLE PAR UN AUTRE DE LA MEME VALEUR

		This light and the one on the front of the
		subwoofer will glow green if the
		amplifier is currently operational, and
		red for 5 seconds during start-up or if
		the amplifier is set for auto-on that is
		not currently activated. It will flash in
		various colors and patterns when heat
		or line voltage is a problem.
		Set this adjustment to match the
		distance from the side of the subwoofer
		to the side wall of the room (in meters).
		Set this adjustment to match the
		distance from the rear of the subwoofer
		to the rear wall of the room (in meters).
		This level adjustment functions only for
		the LFE input. If you are not using the
Side Wall Distance	meters	LFE input, set this to minimum
Rear Wall Distance	meters	(OFF). If the subwoofer volume is set
LFE Level		by the processor then a good starting
		point is 90.
		This displays the current setting of the
		adjustment designated by the light
		above.
Increase		This button increases the active setting.
		This button selects which setting is
Select		active.
		This button decreases the active
Decrease		setting.

Connect an input cable to this connec-

LFE Inputtor if the subwoofer is being used for the processor’s subwoofer output.

LFE Output	If the LFE input is used, this connector
	can connect to an additional subwoofer.
	Connect an input cable to this connec-
Normal Input	tor if the subwoofer is being driven by a
	crossover or Integrator.

If the Normal input is used, then this connector can be used to connect to an additional subwoofer.

			Normal Output
Model
Ser No
Voltage
Fuse			Trigger On
120v 8A
240v 4A	Off	On	On
Slo-blow
			Auto
THIEL Audio	• 1026 Nandino Boulevard •Lexington, Kentucky •USA		• www.thielaudio.com

See page 14 for fuse replacement Power cord plugs here Turn power on here

DC voltage (5-25 volts) to this jack will turn the amplifier on if the auto/on switch is set to auto. Removing the voltage turns the amp off.

Setting this switch to On turns the amplifier on (after a 3 second start-up delay) provided that the main power switch is on. The Auto position allows the amplifier to automatically turn on when it detects an input or a trigger.

11