Note: The RSSI value can be configured through management interfaces to display a value for specific WDS bridge links.
|
| 11b/g | Power |
High 11a | Signal | 11a | Link |
|
| ||
|
| 11b/g | Power |
Medium 11a | Signal | 11a | Link |
|
| ||
|
| 11b/g | Power |
Low 11a | Signal | 11a | Link |
|
|
1
2
3
Pan the antenna horizontally back and forth while checking the LEDs. If using the pole- mounting bracket with the unit, you must rotate the mounting bracket around the pole. Other external antenna brackets may require a different horizontal adjustment.
Find the point where the signal is strongest (all LEDs on) and secure the horizontal adjustment in that position.
Note: Sometimes there may not be a central lobe peak because vertical alignment is too far off; only two similar peaks for the side lobes are detected. In this case, fix the antenna so that it is halfway between the two peaks.
Loosen the vertical adjustment on the mounting bracket and tilt the antenna slowly up and down while checking the LEDs.
4Find the point where the signal is strongest and secure the vertical adjustment in that position.
Troubleshooting
Refer to the 3Com
13
