Troubleshooting…
No Sound?
Transmitter is not initialized –
Check the audio signal source both to and from the transmitter. Try another cable to ensure integrity.
Check the receiver amplifier, if used, is powered “on”at the mains, is not on “mute”, has no headphones attached and that the Channels used for the transmitter/ exterior speakers (usually A or B) is in operation.
Refer to the owners guide that came with your receiver amplifier.
Check the “on” switch at the Remote Control to make sure the speaker is switched “on”. Check the volume control on your Remote Control is switched high enough for volume to be heard.
Check the “Green” indicator light on your speakers to ensure they are receiving a signal. Ensure you speakers are receiving power. Red LED..
No Sound from one speaker
Check the “balance” control on your receiver amplifier is “equal”.
Check all connections and cable to and from, or the integrity of the transmitter source to the inoperable speaker.
Check the batteries or power source(s) to the inoperable speaker.
Speaker has intermittent or rough sound; the distance of the remote control volume controller becomes nearer
One speaker sounds distorted, lower volume
Loudspeaker is flashing red or full light – the battery of the loudspeaker or remote control will soon be out of power. Please replace.
Check the “range” by temporarily bringing the exterior speakers closer to the transmitter source.
Lift the transmitter height to see if this has any effect.
Follow same procedure as above for “No Sound”
11