a soft rubber protector. Locate the supplied mains cable, plug in connection cable and push in firmly then screw on its protective cover, then plug in the connection at the wall mains plug.
3.Locate the silicone covered “On & Off” switch. Switch “On” the Red rocker switch and note the Green LED light comes on which shows the unit is operating and ready to receive a broadcast signal.
4.Note: At this time you should test the operation of the units using the mains power only to ensure correct operation of the system so far.
5.Switch off the units rocker switch and disconnect the mains cable connection. Note the Screw On/ Off Battery cover. Carefully screw off this cover and remove the battery container. Insert 6x AA batteries. Switch on using the rocker switch and, again note the Green operating LED light. The unit should now be prepared to operate on batteries only.
6.Note: At the base of the wireless rock speakers is a Red LED light. Should the units receive power fluctuations or the batteries lose charge this red LED light should flash in warning of insufficient power to the units. You may also experience a lessening in range and performance.
7.Note: Batteries leak power and lose their charge. Avoid leaving the batteries installed when using mains power or during periods of inactivity.
WRS010 Remote Control
1. Once the Transmitter and rock speakers are set up and ready for operation please study your WRS010 system Remote Control pad.
2. On the back of the unit, please slide off/ down the battery compartment cover plate. Insert 1x MN21/23 or 1x 23A battery. Replace the battery cover
3. Press the “ON/ OFF” button on the remote; if powered you may hear a pop noise from the speakers notifying you they are receiving. The “Red” LED light will flash on whenever you operate a remote control button.
4. Ensure your transmitter and speakers are operational with the transmitter receiving an Audio Source Signal. Press and hold the “Vol +” button for a short time until the speakers reach an appreciable volume level.
7
