Timex W223 NA, 222-0950012 manual Tachymeter Ring, Compass Ring, To Measure the Time Remaining

ENGLISH

TO MEASURE THE TIME REMAINING:

Set the triangle to the hour or minute position when you wish to complete the activity, and check the watch periodically for progress towards that goal.

In the illustration shown on the previous page on the right you can stop when the minute hand reaches

ENGLISH

If within the first minute, a distance greater than one mile or kilometer is covered, multiply the tachymeter number by the distance to get the actual rate: if you went 1.2 miles in 45 seconds, multiply the 80 by 1.2 – 96 MPH.

the 20 minutes past the hour position.

TACHYMETER RING

The tachymeter feature can be used to measure speed in miles per hour (MPH), nautical miles per hour (knots) or kilometers per hour (KPH) using the sweep second hand and the scale on the wall above the watch face. You need to know the actual dis- tance you are covering in miles or km.

Start the chronograph with the second hand at zero (the twelve o’clock position). Within the first minute, the second hand will point to the rate for a one-mile (or one kilometer) course: if it takes 45 seconds, the hand will point to 80 at that position – 80 MPH

or 80 KPH.

COMPASS RING

If your watch is equipped with a movable ring around the dial marked at the let- ters “N”, “E”, “W”, “S” (for the four compass direc- tions) or compass degrees, you can use this feature to find an approximate compass directional reading.

1)Lay the watch on a flat surface, or hold it so that the face is parallel to the ground.

2)Locate the sun and point the hour hand at the sun.

S	1112	1	W
10			2

9 3

8			4
E	7	6	5

N

40 41