TOA Electronics manual BLANK SKIP FUNCTION BA-800, BA-806and BA-823

7.FAULT INDICATION [BA-800, BA-806 and BA-823]

If a cassette player unit (TAPE 1 or 2) malfunctions, the corresponding tape travel indicator flashes.

	Tape travel indicator
TAPE 1	TAPE 2
Flashes when TAPE 1 deck malfunctions.	Flashes when TAPE2 deck malfunctions.

If either indicator flashes, make no further attempt to use the corresponding cassette player unit. Eject the tape

immediately and replace the faulty cassette player unit with a new one. The cassette player unit of other indicator

that does not flash can still be used.

[Note]: The tape travel indicator also flashes when the cassette player unit is removed, but this does not infer real

malfunction. You can still use other cassette player unit unless its tape travel indicator is flashing. For

cassette player unit (CU-800) replacement, refer to p.27.

8. "BLANK SKIP" FUNCTION [BA-800, BA-806 and BA-823]

Your tape player comes with a Blank Skip function. If an unrecorded section in the tape lasts for ten seconds or

more during playback, the tape is automatically sent forward at top speed to skip the unrecorded section to re-start

playback from the top of a next piece of music.

The Blank Skip function can be made available by setting the blank skip switch to ON.

[Note]: The function may operate in the middle of playback if an extremely low recording level tape is used or if

the tape contains a relatively long low signal level section, such as pianissimo. In such cases, set the blank skip switch to OFF.

— 26 —