TOA Electronics SSDV-3328 Electronic Appliance Checkout, Install Logs, Volcanic Stone

Replace logs if removed for pilot inspection.

To light the burner; turn “ON” the remote wall switch and rotate the gas valve control knob counterclockwise to the “ON” position.

HONEYWELL MILLIVOLT PILOT ASSEMBLY

Proper Pilot Flame Appearance

	Thermocouple
1/8" Min.	Igniter Rod
(3 mm)	Hood

3/8" Min.

(9 mm)

Pilot

Nozzels

Thermopile

Figure 50

Electronic Appliance Checkout

To light the burner, turn ‘ON’ the optional remote wall switch and turn the gas control switch to the “ON” position. Ensure the Igniter lights the pilot. The pilot flame should engulf the flame rod as shown in Figure 51.

INSTALL Logs, VOLCANIC STONE and

GLOWING EMBERS

Carefully position the ceramic fiber logs and twigs over the burner according to the following steps, while referring to Figure 52.

1.Set the rear log on the raised log support brackets at the rear of the firebox, fitting the slots in the log over the brackets.

2.Position the front log with the pins for the two side twigs in the up position, and the two vertical burner tabs recessed into the two notches at the rear of the log. Check for recessing of brackets into log notches (by touch) to verify correct log placement.

3.Insert the alignment hole of the left twig over the front log's left pin. Rotate the left twig until it just touches the edge of the ember bracket.

4.Insert the alignment hole of the right twig over the front log's right pin. Rotate the right twig until it almost touches the front panel glass.

Note: Proper twig placement is critical in the gaps between the flame peaks and should be positioned so that at no time they impinge the flames.

Glowing Ember/Volcanic Stone Placement

Remove the replacement rockwool (Glowing Embers) from the packaging and tear into quarter size pieces (see Figure 53 ).

Spread rockwool (quarter-sized pieces) on and along the length of the burner screen. Do not use more than is necessary. To many quarter- sized pieces on the front burner section will cause poor combustion.

When properly positioned, the rockwool will unevenly cover approximately 85% of the burner screen, with no appreciable gaps or openings.

To install Decorative Volcanic Stone, mound up a portion of the volcanic stone in front of the burner in a pattern to suite individual taste.

28

ELECTRONIC PILOT ASSEMBLY
Proper Pilot Flame Appearance
Proper Flame	3/8" to 1/2"
Adjustment	(9 -13 mm)
Pilot
Nozzels
	Hot Surface
	Igniter
Figure 51

Figure 52 - Log Set (Shown With Optional Log Rack)

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.