III. OPERATION
A.Location and Function of Controls
This section provides a basic description of the toaster controls, their location, and the functions they perform. The operator MUST be familiar with the controls. See Figure 3.
Figure 3 -Toaster Controls
Operating
Lever
Color
Selection
Knob
1.Color Selection Knob
Adjusts the darkness of the toasted bakery product.
•Turn the knob to the LEFT for lighter toasting.
•Turn the knob to the RIGHT for darker toasting.
2.Operating Lever
•Press the lever DOWN to load the bakery product into the toaster.
•Push the lever UP to manually raise the product during the toasting cycle. If the operating lever is not raised manually, it will be automatically raised at the end of the toasting cycle.
B.Operation Procedure
CAUTION
THE REMOVABLE CRUMB TRAY MUST BE IN PLACE BEFORE THE TOASTER MAY BE OPERATED. If the tray is removed for cleaning, ensure that it is replaced before operation.
1.Insert the bakery product into the slots. For
Figure 4 - Loading extra-wide, one-sided slots
Models HT409/424, BTW09/24 only
Side of bakery product to be toasted faces
LEFT
2.Turn the color selection knob (if necessary) to set the desired darkness. A medium color setting is achieved at the 9 o’clock position.
NOTE
It will be necessary to determine the color setting for each different bakery product that is to be toasted. Test a single piece at the 9 o’clock setting, and then adjust the Color Selection Knob as necessary to find the proper setting.
3.Press the Operating Lever DOWN to lower the product into the toasting chambers.
4.Wait for the toasting cycle to complete, and the toasted product will automatically be raised.
OR
Push the Operating Lever UP to manually raise the product at any time during the toasting cycle.
C.Clearing Jams
WARNING
DISCONNECT THE TOASTER FROM ITS ELECTRICAL POWER SUPPLY BEFORE ATTEMPTING TO CLEAR A JAM.
WARNING
DO NOT TOUCH HOT SURFACES ON THE TOASTER, OR REACH INTO THE TOASTING CHAMBER, UNTIL THE UNIT HAS COOLED THOROUGHLY.
WARNING
NEVER INSERT A KNIFE, FORK, OR SIMILAR OBJECT INTO THE TOASTING CHAMBER. THIS CAN CAUSE AN ELECTRICAL SHOCK OR DAMAGE THE HEATING ELEMENTS.
D.Cleaning
WARNING
DISCONNECT THE TOASTER FROM ITS ELECTRICAL POWER SUPPLY BEFORE CLEANING OR SERVICING.
WARNING
DO NOT TOUCH HOT SURFACES ON THE TOASTER, OR REACH INTO THE TOASTING CHAMBER, UNTIL THE UNIT HAS COOLED THOROUGHLY.
WARNING
WHEN CLEANING THE TOASTER, NEVER APPLY ENOUGH LIQUID TO STAND IN PLACE ON THE UNIT. DO NOT SPRAY, RINSE, OR SUBMERGE THE TOASTER. EXCESSIVE MOISTURE IN THE UNIT WILL CAUSE A SEVERE ELECTRICAL HAZARD AND MAY OTHERWISE DAMAGE THE TOASTER.
CAUTION
DO NOT clean your toaster using abrasive cleaners or pads. Both will scratch and dull the finish.
1.Wipe the exterior of the toaster with a sponge or cloth soaked in hot or warm detergent water. Wipe with a clean, damp cloth to remove the excess detergent, and then wipe again to dry the toaster.
2.Remove the crumb tray, and empty it. Wash the crumb tray in warm detergent water, and rinse it.
3.After the crumb tray is dry, replace it in the toaster.
3