CHAPTER 6 – CLEANING & MAINTENANCE

In order to keep your machine in good working order we recommend that you follow the procedures below. Always make sure that the machine is cold and disconnected from the mains before carrying out these steps:

6.1. WATER & STEAM DRIP TRAYS

Empty the two plastic drip trays under the drip tray grills. Wash the trays in water using a mild detergent. We recommend this is done daily.

6.2. STEAM ARM

After using the steam function, wait for the arm to cool down before cleaning the arm with a damp cloth. Avoid using abrasive materials.

6.3. POD HOLDER FILTER

This is located on top of the pod holder above where the spout enters the assembly. Very carefully insert a flat screwdriver between the filter and the body of the assembly being careful not to damage the machine. Take the filter out and clean it in water. To re-fit the filter place it back on top of the pod holder making sure it is properly seated and then slowly push the gearlever away from you to lift up the pod holder assembly. Keep going until the gearlever locks into position. You can now pull the gearlever back. Check that the filter is properly fitted.

NOTE: It is only necessary to clean the pod holder filter periodically when you notice that the coffee does not appear to be flowing freely or when you notice a build up of residue on the filter.

You can clean the spout by pulling it out from the pod holder assembly and rinsing it in water. To re-fit put the spout back in the pod assembly push it until the spout is fully engaged. Ensure that the end of the spout is facing downwards.

6.4. CLEANING THE CHROMIUM-PLATED PARTS

Your Lamborghini coffee machine is supplied

23 – TONINO LAMBORGHINI EPS

Use and maintenance manual – Rev.01 - 07/2006