CHAPTER 7 - TROUBLESHOOTING

If you have a problem with your machine please look at the table below to see if the issue is covered. If not, please contact the retailer who should be able to resolve the issue.

7.1. PROBLEMS DESCRIPTION AND SOLUTIONS

 

 

Problem

Resolution

 

 

 

The machine will not switch on

Check that the machine is plugged into a

 

 

 

 

 

230-240 volt mains supply.

 

 

 

The coffee is not hot enough

Pre-heat the coffee cup before use

 

 

 

 

Coffee comes out very slowly from

The pod holder filter may need cleaning

 

 

 

 

he spout

(see Par 6.3)

 

 

 

 

The spout may need to be cleaned out

 

 

 

 

(see Par 6.3)

 

 

 

The machine does not dispense

Check that the pod assembly is properly

 

 

 

 

coffee through the spout.

closed by pushing the gearlever as far

 

 

 

 

forward as you can. It should lock into

 

 

 

 

place.

 

 

 

 

If you have just finished using the steam

 

 

 

 

the boiler will need to cool down before

 

 

 

 

it can produce hot water for coffee.

 

 

 

 

Check that the steam button is not

 

 

 

 

pushed in. Again, allow the boiler to cool

 

 

 

 

down. This may take a few minutes.

 

 

 

 

If the problem persists contact the

 

 

 

 

retailer.

 

 

 

The pump can be heard working

Checking the level of the water in the

 

 

 

 

but the machine does not dispense

reservoir and check that the water pipes

 

 

 

water.

are able to reach the bottom of the

 

 

 

 

reservoir.

 

 

 

 

Check that the water pipes are not

 

 

 

 

kinked.

 

 

 

 

Switch off the machine and retry after a

 

 

 

 

few minutes or just open the steam

 

 

 

 

release knob for a few instant and retry.

 

 

 

 

 

 

 

 

 

 

 

26 – TONINO LAMBORGHINI EPS

Use and maintenance manual – Rev.01 - 07/2006