| The boiler may need refilling (See Par. |
| 7.2) |
| Also check the other answers given in |
| this table. |
| If the problem persists, contact your |
| retailer. |
The machine does not dispense | Check the previous point. |
water or steam | If you can hear the pump working |
| |
| correctly then the boiler may require de- |
| scaling (after dispensing approx. 2,500 |
| coffees depending on the hardness of |
| the water) In this case please contact |
| your retailer. |
The pod holder leaks when | The coffee in the pod may be too finely |
dispensing hot water to make | ground or may be too big for the holder. |
coffee. | Alternatively, the coffee pod may not be |
| seated centrally in the coffee pod holder. |
| If you have already made a 1,000 cups |
| of coffee then the orange rubber sealing |
| ring may need to be replaced (see Par |
| 6.7) |
It takes a long time for the coffee | The coffee pod may not be fresh. Try a |
to come out and there is little | fresh coffee pod. |
crema produced. | The boiler is scaled up and may require |
| |
| descaling – Contact your retailer. |
7.2. FILLING THE BOILER
After a long period of not using the machine the boiler may need to be refilled. To do this proceed as follows:
1 | Fill the water reservoir and put the two | ||
|
| water pipes back in making sure that there | |
|
| are no kinks in the pipes. | |
2 | Close the pod holder assembly by pushing | ||
|
| the gearlever on the right hand side away | |
|
| from you until it locks into position. | |
3 | Connect the machine to an electric socket; | ||
4 | Turn on the machine and the red LED lights | ||
|
| will illuminate. | |
|
|
|
|
27 – TONINO LAMBORGHINI EPS | Use and maintenance manual – Rev.01 - 07/2006 | ||