ASSEMBLING THE
ATTACHING UTILITY BRUSHES
WARNING: Do not try to connect accessories while unit is emitting steam.
This section applies to all Utility Brushes. Note that Utility Brushes attach to Steam Jet Nozzle, not to main steam nozzle.
1.Align guide tab on inside of Utility Brush (FIGURE
2.Press Utility Brush as far on to Steam Jet Nozzle as possible to ensure that it is properly sealed, to help prevent any steam leakage (FIGURE 4).
3.To remove Utility Brush, simply grip it firmly and pull it off of Steam Jet Nozzle.
USING THE
FILLING WATER RESERVOIR WITH WATER
1.Place
2.Make sure Lighted On/Off Switch is set to “Off” position and grounded power cord is unplugged from electrical outlet.
3.Flip up Storage Compartment lid. Cautiously unscrew and remove Water Reservoir cap.
4.Water Reservoir should always be emptied after each use. If it was not emptied after the last use, empty it now. This will prevent
5.Fill Measuring Cup to maximum fill line (16 oz. / 473 ml.) with water.
NOTE: To prolong the life of your
6.Carefully pour water from Measuring Cup into Water Reservoir through fill hole.
WARNING: Extreme caution should be used when pouring water into the Water Reservoir. Do not look directly down into fill hole when filling. Keep your free hand and any children or pets at a safe distance.
7.Depending on how long you intend to steam, you may repeat steps 5 & 6 up to two more times, to have up to a maximum of 48 oz. (1,420 ml.) of water. See chart for a comparison of the amount of water vs. approximate steam time.
FIGURE 3
ATTACHING SCRUB PAD
This section applies to the Scrub Pad. Note that Scrub Pad attaches to Steam Jet Nozzle, not to main steam nozzle.
1.Place Scrub Pad over tip of Steam Jet Nozzle, and firmly press it as far on to Steam Jet Nozzle as possible to ensure that it is properly sealed (FIGURE 5). This will help prevent any steam leakage.
2.To remove Scrub Pad, simply grip it firmly and pull it off of Steam Jet Nozzle.
FIGURE 4
FIGURE 5
8.Replace Water Reservoir cap, ensuring that it is screwed on tightly to prevent hot steam from escaping and causing injury.
9.Lower Storage Compartment lid back down.
REFILLING WATER RESERVOIR AFTER USE
If unit has been in use, always follow the safety precautions below before removing the Water Reservoir cap:
1.Allow unit to cool for 5-10 minutes.
2.Press and hold Steam Button to release all remaining steam.
WARNING: Failure to follow these precautions may result in burns from escaping steam when the Water Reservoir cap is removed.
8 | Top Innovations, Inc. | Top Innovations, Inc. | 9 |
