ASSEMBLING THE FABRIC STEAMER
CONNECTING HOSE
1.Slide Hose fitting onto threaded Hose Base (FIGURE 5)
2.Turn Hose fitting clockwise to secure it to Hose Base (FIGURE 6).
NOTE:
3.Hang Steam Nozzle on specially designed Steam Nozzle Holder as shown (FIGURE 7).
CAUTION: To prevent steam from causing bodily injury or damage to surfaces, always hang Steam Nozzle on Steam Nozzle Holder when not in use. Do not lay Hose on floor as condensation may build up inside, causing unwanted water droplets in steam.
CAUTION: Pulling on Hose with excessive force may damage it, resulting in a steam leak.
FIGURE 5 | FIGURE 6 | FIGURE 7 |
ATTACHING LINT REMOVER /
FABRIC BRUSH / CLOTH COVER
1.Make sure Lighted On/Off Switch is set to “Off” position, and that unit is not emitting any steam. Do not try to connect Lint Remover, Fabric Brush or Cloth Cover while unit is emitting steam, as this can cause burns and injury.
2.Align two pegs on back of accessory with corresponding holes on face of Steam Nozzle. Use care to properly align attachment as shown (FIGURE 8), so as not to cover up steam holes
on nozzle face.
3. Press accessory firmly onto Steam Nozzle, until FIGURE 8 it fits securely in place.
8 | Top Innovations, Inc. |
