Managing Multiple Handsets, English

Topcom Butler B3500/3501/Twin

5.1.3Deleting an entry To delete an entry:

1.Enter the menu by pressing /OK

2.Select PHONE BOOK using the up and down keys

3.Press OK

4.Select DELETE ENTRY using the up and down keys

5.Press OK

6.Move through the list of names using the up and down keys the list scrolls in alphabetical order.

7.Press OK when you find the name you wish to delete

8.CONFIRM appears, press OK to confirm or to stop.

5.2 SEARCHING A HANDSET FROM THE BASE

When the paging button on the base is pressed all the handsets will ring. This ringing will help you locate a lost handset. By simply pressing one of the handset keys the ringing stops.

6. MANAGING MULTIPLE HANDSETS

6.1SETTING UP AN ADDITIONAL HANDSET

!!!YOU ONLY NEED TO REGISTER A 2nd HANDSET IN CASE YOUR 2nd HANDSET DOES NOT LINK WITH THE BASE ANYMORE OR WHEN YOU HAVE BOUGHT A NEW ONE !!!

You can register new handsets on the base if these handsets support the DECT GAP protocol.

The base can support a maximum of 2 handsets. If you already have 2 handsets, and you wish to add another one or change one handset, you must first delete a handset, then associate the new handset.

To register any handset, the base must be put into a special registration mode:

1.Press and hold the paging key of the base for 6 seconds.

2.The base will then emit a beeptone. The base is now ready to register a new handset. You have 90 seconds after pressing the button to register a new handset.

After putting the base into registration mode, start the procedure on the new handset:

if your additional handset is a Butler 3500xC

3.Enter the menu by pressing /OK

4.Select REGISTER using the up and down keys

5.Press OK

6.Select REG BASE using the up and down keys

7.Enter a base number ( from 1 to 4 ). The flashing numbers are already in use.

8.Enter the Base PIN code (0000 by default )

9.Press OK. The handset will start searching for the DECT base

10.If the handset has located the base, it will display the base identification number, validate the base registration by pressing OK or stop by pressing .

11.If the handset does not locate the base, it will return to the standby mode after a few seconds. Try again by changing the base number and check that you are not in a environment where there is interference. Move closer to the base.

if your handset is another model

After starting the registration procedure on the base, refer to the handset manual to find out how to register the handset. The handset must be GAP compatible.

The icon and the text "NOT REG" flashes on the display when the handset is not associated with the base. When a handset is associated with a base, it is attributed a handset number by the base. It is this number that is displayed on the handset after the name and must be used for internal calls.

ENGLISH