Topcom DIABLO 103 5.5 Direct access memory (Key 1,2,3 and M1), 5.5.1 Programing the direct memory keys, 5.6 Mute function , 5.7 Setting the volume, 5.9 Flash button (R), 5.10 Programming procedure, 5.10.1 Handset External melody and volume, 5.10.2 Handset Internal melody and volume

Topcom Diablo 100/Twin/Triple/Quattro 5

Topcom Diablo 100/Twin/Triple/Quattro

ENGLISH

5.5 Direct access memory (Key 1,2,3 and M1)

The product has 3 locations (Key ‘1’, ‘2’ and ‘3’) where you can store a number under and dial it by

pressing and holding one of these keys in standby. The phone will automatically take the line and dial

the number which is stored under this key. The number stored under key ‘1’ can also be dialed out by

pressing the ‘M1’-key shortly in standby.

5.5.1 Programing the direct memory keys

Press the Memory button short. Press and hold the Memory button until the -icon appears on

the display. Press and hold one of the 3 direct memory keys (Key 1,2 or 3) where you want to store the

number under until ‘Sx - _’ appears. Î Enter the telephone number you whish to store. Î Press

the Memory button again to confirm. Î You will hear a confirmation tone and the next entry will

appear. To leave the direct memory programming, press the On-hook button .

5.6 Mute function

It is possible to deactivate the microphone during a conversation. Now you can speak openly without

being heard by your correspondent. Press the Mute button during a conversation. to deactivate or

activate the microphone.

5.7 Setting the volume

During a conversation you can set the volume by pressing the scroll button . You can set the

volume between 1-5.

5.8 Paging

When you press the Paging button on the base unit, the handset emits a ringing signal for 20 seconds.

This signal helps you find a lost handset. Press any key to stop the ringing on all handsets.

5.9 Flash button (R)

When you press the R button, also called flash or recall, the unit generates a line interruption (of 100 ms

or 250 ms). It gives you the possibility to use the special services of your telephone provider and/or to

transfer calls when you have a telephone exchange. You can change the flash time if needed (See

“Setting the Flash time” on page6).

5.10 Programming procedure

You can change the ring melodie, volume, day, time etc... by going into the program procedure: To go

into the program procedure you have to press and hold the Program button until the icon starts to

flash. Î Press the Program button again to change the first setting. Each time you press the Program

button you will confirm the previous setting and jump to the next setting:

External ring volume/melody

Internal ring volume/melody

Date/time setting

Dial mode setting

Flash time setting

Base ring volume/melody

5.10.1 Handset External melody and volume

Press and hold the Program button until the icon starts to flash. Î Press the Program button

again, the external melody is heard and the EXT-icon is flashing. Î Select the desired melody (1-5)

by entering a number (1 - 5). Î Use the scroll keys to select the desired volume (Off or 1-5) Î

Press again to confirm the setting and to go to the next setting below.

5.10.2 Handset Internal melody and volume

The internal melody is heard and the INT-icon is flashing. Î Select the desired melody (1-5) by

entering a number (1 - 5). Î Use the scroll keys to select the desired volume (Off or 1-5) Î

Press again to confirm the setting and to go to the next setting below.