Toro 20066, 20067 manual Adjusting the Self-propelDrive Cable

Figure 32

4.Remove the blade, saving all mounting hardware (Figure 32).

5.Install the new blade and all mounting hardware (Figure 33).

Figure 33

Important: Position the curved ends of the blade to point toward the mower housing.

6.Use a torque wrench to tighten the blade bolt to 60 ft-lb (82 N⋅m).

Important: A bolt torqued to 60 ft-lb (82 N⋅m) is very tight. While holding the blade with a block of wood, put your weight behind the ratchet or wrench and tighten the bolt securely. This bolt is very difficult to overtighten.

Adjusting the Self-propel Drive Cable

Whenever you install a new self-propel cable or if the self-propel drive is out of adjustment, adjust the self-propel drive cable.

1. Loosen the cable support nut (Figure 34).

Figure 34

2.Pull down the cable jacket (toward the mower) until there is no slack in the cable (Figure 35).

Figure 35

3. Tighten the nut on the cable support.

17