Toro 22621223-24 manual Engine Mount Arm Installation, Adjustment Of The Hose Length

2-8 Engine Mount Arm Installation

Slide the engine mount arm assembly (Figure 10) into the outer engine mount tube. Secure the engine mount arm assembly using (1) detent pin P#(J0248).

Figure 10 Engine Mount Arm

Detent Pin

2-10 Adjustment Of The Hose Length

THE HOSES IN STEPS 2-11 AND 2-12 MUST BE CUT TO FIT YOUR MACHINE. FOLLOW STEPS 2-11 AND 2-12. DO NOT CUT THE HOSES UNTIL YOU HAVE TRIED TO FIT THEM ON YOUR MACHINE. REMEMBER THAT THE HOSES HAVE TO BE LONG ENOUGH TO ALLOW FOR ENOUGH CLAMPING SURFACE BETWEEN THE INLET, BLOWER ASSEMBLY, AND THE DECK BOOT.

2-11 Attachment Of The Upper Hose

Slide a 5”-6” upper hose clamp P#(J6011) onto both ends of the 6” upper hose (Figure 12). Then slide one end of the 6” hose onto the inlet. Make sure there is about a two-inch overlap between the hose end and the container inlet. Proceed to slide the opposite end of the 6” hose onto the outlet of the blower assembly. See (Figure 12) for details. Make sure both ends of the hose are clearly attached to the inlet and the blower assembly inlet. Tighten the hose clamps.

2-9 Engine/Blower/Blade Assembly Installation

Place the engine/blower/blade assembly onto the engine mount arm assembly (Figure 11). Secure the engine/blower blade assembly to the engine mount arm assembly using (4) 5/16"-18 x 1-1/2" hex bolts P#(K1157) and (4) 5/16"-18 flange nuts P#(K1178).

2-12 Attachment Of The Lower Hose To The Engine/Blower/Blade Assembly

Slide a 7”-8” hose clamp P#(J6006) over both ends of the lower hose. Then proceed to slide the lower hose onto the blower cone. Tighten the hose clamp. The assembly should look like (Figure 12).

Figure 11 Engine/Blower/Blade Installation

Figure 12 Hose Assembly

Inlet

Upper Hose

5/16" x 1-1/2" Bolt Lower Hose Boot

9