TOSHIBA 4200FA UPS
Installation Planning Guide for
Standard System: 208/120V Input, 208/120V Output
Important Notes:
1.Maximum Current required at Primary AC Input based on full load output and maximum battery charging current.
2.Output load conductors are to be installed in separate conduit from input conductors.
3.Control wires and power wires are to be installed in separate conduits.
4.Recommended AC input and output overcurrent protection based on continuous full load current per NEC.
5.Wiring shall comply with all applicable national and local electrical codes.
6.Grounding conductors to be sized per NEC Article
-Primary AC Input: 3φ,
-AC Output: 3φ,
-DC Input:
7.Nominal battery voltage based on the use of VRLA type batteries (2.0 volts / cell nominal).
8.Maximum battery discharge current based on lowest permissible discharge voltage of 1.6 VPC.
9.DC wires should be sized to allow not more than a
10.Weights include internal batteries.
11.Sizing calculations based on the following assumptions:
-Not more than 3
-Temperature rating of conductors and terminals: 90 deg. C.
-Feeder distance calculations based on NEC Tables 8 and 9 data, allowing for 2% AC voltage drop.
-Reference: 2002 NEC Handbook. Consult latest edition of applicable national and local codes for possible variations.
12.Ratings of wires and overcurrent devices are suggested minimums. Consult with a registered Professional Engineer within your local area for proper size selections.
TOSHIBA INTERNATIONAL CORPORATION
13131 West Little York Road
Houston, TX 77041
Telephone: 800.231.1412; 713.466.0277
Fax: 713.896.5212
Corporate Web Site: www.tic.toshiba.com
Group Web Site: www.toshibaups.com
Rev. 1.03 | Page 2 of 2 |
