TOSHIBA

3.0 Precautions

CAUTION

3.1 Installation Precautions (General)

 

1)Install the unit in a well ventilated location; allow at least 10 cm (4 inches) on all sides for air ventilation and for maintenance.

2)Install the unit in a stable, level, and upright position which is free of vibration.

3)Install the unit where the ambient temperature is within the correct operating range (see Specifications Section 4.0).

4)Do not install the UPS in areas that are subject to high humidity.

5)Do not allow direct sunlight to shine on the unit.

6)Do not install the UPS in areas which are subject to contamination such as high levels of airborne dust, metal particles, or inflammable gas.

7)Avoid installation near sources of electrical noise and always make sure that the unit ground is intact to prevent electrical shock and to help reduce electrical noise.

8)Do not install where water or any foreign object may get inside the UPS.

9)This UPS generates and can radiate radio-frequency energy during operation. Although RFI noise filters are installed inside the unit, there is no guarantee that the UPS will not influence some sensitive devices which are operating close by. If such interference is experienced, the UPS should be installed farther away from the affected equipment and/or powered from a different source than that of the affected equipment.

3 - 1

Page 13
Image 13
Toshiba 1500 SERIES operation manual Installation Precautions General