Using the Remote Control
Using the remote control
Learning about the remote control
POWER turns the TV on and off (Standby)
The power indicator is illuminated in red.
MUTE mutes the sound (page 26)
RECALL displays
MTS switches Stereo or SAP sound (page 26)
TV/VIDEO selects the video input source (page 20)
Channel Numbers
ENTER sets programming menu information (page 17) yz x • select or adjust programming menus (page 17) CH yz cycles through programmed channels (page 18)
adjusts the volume level
CCselects the Caption or Text mode (page 24, 25)
MENU allows access to
SLEEP allows access to the automatic TV
SOUND selects the sound mode (page 28)
cycles through favorite channels (page 19)
Installing the remote control batteries
To install the batteries:
1.Open the battery cover of the back of the remote control.
2.Install two batteries (R03 size “AAA”). Match the + and – signs on the batteries to the signs on the battery compartment.
3. Close the battery on the remote control until the lock snaps.
Remote control effective range
MUTE POWER
TV/VIDEO MTS RECALL
1 2 3
4 5 6
7 8 9
CH RTN
0100/
CH 
VOL ENTER VOL
CH
EXIT MENU CC
SOUND PICTURE SLEEP
FAV. CH
Caution:
Never throw batteries into a fire.
Note:
•Always dispose of batteries in a designated disposal location.
•Batteries should always be disposed of with the environment in mind. Always dispose of batteries in accordance with applicable laws and regulations.
•If the remote control does not operate correctly, or if the operating range becomes reduced, replace batteries with new ones.
•When necessary to replace batteries in the remote control always replace both batteries with new ones. Never mix battery types or use new and used batteries in combination.
•Always remove batteries from remote control if they are dead or if the remote control is not to be used for an extended period of time. This will prevent battery acid from leaking into the battery compartment.
16
