Using V-CHIP Control

Some TV programs and movies include signals that classify the content of the program (violence, sex, dialog, language). The V-CHIP Control feature in this TV detects the signals and blocks the programs according to your selections.

To use this feature, perform the following setup.

RECALL MUTE

RECALLo

POWER

Selecting the V-CHIP CONTROL menu

1 Press MENU then s or t repeatedly until “V-CHIP CONTROL” in the Set up menu is displayed in purple.

TIMER:

0 MIN

TV/CABLE:

[TV]CABLE

CH PROGRAM

 

ADD/ERASE:

[ADD]ERASE

T/ S

1 2 3

4 5 6

7 8 9

CH RTN

100 0 ENT

CH

VOL MENU/ VOL

ENTER

Number buttons

2 Press T or S to display the pin code entering mode.

●Factory reset status

Set your 4 digit code by pressing the

Number buttons (0-9).

s/ t

Example: To enter “1110”

V-CHIP CONTROL

FAVORITE CH

MOVE[t s] START[T S]

BLOCKING IS RESET

PLEASE ENTER NEW PIN CODE

1110

MENUCH

TV

CABLE

VCR EXIT

Press 1, 1, 1, and 0 in order.

EXIT

SELECT[0-9] END[EXIT]

Advanced Operaion

FAV CH TV/VIDEO

A

REC TV/VCR STOP PLAY

SLOW PAUSE REW FF

To return to the normal picture

Press EXIT.

●When the pin code is already stored Press the Number buttons (0-9) to enter the 4-digit pin code used to block channels.

If a wrong pin code has been entered

This message will appear. Try to enter the correct code again.

If you can not remember the pin code you have stored, while in the pin code entering mode, press the RECALL button four times within 5 seconds.

The pin code you have stored will be released. (Factory reset status).

3 After about 1 second, the screen changes to the V-CHIP CONTROL menu as shown.

Continue to set each item following the steps on the next page.

BLOCKING IS ACTIVE PLEASE ENTER PIN CODE

1234

SELECT[0-9] END[EXIT]

INCORRECT PIN CODE PLEASE ENTER PIN CODE

1235

SELECT[0-9] END[EXIT]

ENABLE BLOCKING : Y[N] SET RATING

SET BLOCKING OPTIONS NEW PIN CODE BLOCK CHANNEL

MOVE[t s] SELECT[T S]

28