Unblocking programs temporarily

1 If you try to watch a TV program that exceeds the rating limits you set, the TV will enter into the program block mode.

THIS PROGRAM HAS BEEN BLOCKED!

TV–PG L V

EXCEEDS SET LIMITS

PUSH MUTE TO ENTER PIN

CABLE 4

2 If you want to watch the blocked program temporarily, press MUTE.

BLOCK CHANNEL function

With the CHANNEL BLOCK function, you can block specific channels. The TV will not be able to tune these channels with the CHANNEL s/t buttons or Channel Number buttons, unless you clear the setting.

This TV has 8 memory spaces total, 4 for TV mode and 4 for CABLE mode.

To block channels

1 Select a channel you want to block.

2 Select “BLOCK

 

 

CHANNEL” in the V-CHIP

ENABLE BLOCKING : [Y]N

SET RATING

CONTROL menu by

SET BLOCKING OPTIONS

 

NEW PIN CODE

Set up

Preparation

Press the Number buttons (0-9) to enter the 4-digit code you have stored.

BLOCKING IS ACTIVE PLEASE ENTER PIN CODE TO TEMPORARILY UN-BLOCK

pressing t or s.

BLOCK CHANNEL

 

MOVE[t s] SELECT[T S]

Operation

If the number is correct, the block mode will be re- leased.

After 1 second, normal picture will appear.

~~~–

SELECT[0-9] END[EXIT]

3 Press T or S to display the BLOCK CHANNEL menu.

BLOCK CHANNEL [SET]CLEAR

0 0 0 0

Basic

All blocking is disabled until the TV is turned off. It will be enabled when the power is reapplied.

If a wrong pin code is

 

entered, the message

INCORRECT PIN CODE

PLEASE ENTER PIN CODE

appears.

TO TEMPORARILY UN-BLOCK

Enter the correct code

~~~~

 

again.

 

 

SELECT[0-9] END[EXIT]

 

 

4 Press T or S to select “SET”, then press t or s until the channel number to be blocked (“2” in this example) replaces “0” on the display.

SELECT[T S] SET[t s] END[EXIT]

BLOCK CHANNEL [SET]CLEAR

0 0 0 2

SELECT[T S] SET[t s] END[EXIT]

Advanced Operation

5 Repeat steps 1 to 4 for other channels.

6 Select another channel before turning off the TV.

To restore channels

Reference Section

1 Select “CLEAR” following the above steps 2 to 4.

2 Press t or s until “0” replaces the channel numbers.

BLOCK CHANNEL SET [CLEAR]

15 10 6 2

SELECT[T S] CLEAR[t s] END[EXIT]

0 0 0 0

3 Press EXIT to erase the display.

31