1
If more than one number is listed, try each one separately until you find the one that works.
2 Set the TV/CABLE/VCR switch to “VCR” (or “CABLE”).
3 Hold down RECALL while pressing the Number buttons for the three digit code number for your brand of VCR (or converter).
4 Point the Remote Control at the VCR (or at the converter) and press POWER to test the code number.
For future reference, write down the code numbers you used:
VCR CODE CABLE CODE
Notes:
● You have to reprogram the Remote Control when you change its batteries.
● Some newer VCR’s are capable of working on either of two remote codes. These VCR’s have a switch labeled “VCR1/VCR2”.
If your VCR has this kind of switch, and does not respond to all the code numbers for your VCR brand name, set the switch to another position (“VCR1” or “VCR2”) and reprogram the Remote Control.
Refer to the “VCR code table” (or “Cable TV converter code table”) on pages 12 and 13 to find the code number that corresponds to the brand name of your VCR (or converter).
Programming the Remote Control
● This Remote Control is preprogrammed to operate TOSHIBA VCR’s.
● To use VCR’s other than TOSHIBA models (or cable converter), perform the following procedures before operating.
Controlling other brands of VCR’s and cable TV converters
RECALL | MUTE | POWER | RECALL |
| |||
|
| ||
| o |
| POWER |
1 | 2 | 3 |
|
4 | 5 | 6 | Number |
|
7 8 9
CH RTN
100 0 ENT
CH
VOL MENU/ VOL 
ENTER
CH
TV
CABLE
VCR EXIT
FAV CH TV/VIDEO
A
REC TV/VCR STOP PLAY
STILL SOURCE PIP
SLOW PAUSE REW FF
PIP CH
LOCATE SWAP
Set up
Preparation
Reference Section Advanced Operation Basic Operation
11