Toshiba 27A10, 32A10, 36A10 Watching TV Programs or Video input, About the Demonstration Mode, ●To scan the memorized channels in numerical sequence, Tostopthedemonstration

Watching TV Programs or Video input

Basic Operation

TV/VIDEO

CHANNEL t s

MENU TV/VIDEO VOLUME CHANNEL

POWER

MENU T S t s

		POWER	RECALL
RECALL	MUTE
	o
1	2	3
4	5	6	Channel
			Number
7	8	9
		CH RTN
100	0	ENT

Selecting the TV channels

Select a channel in one of the following two ways.

●To scan the memorized channels in numerical sequence

Press CHANNEL s to select the next higher channel. Press CHANNEL t to select the next lower channel.

Press the button again to select the next memorized channels.

●To select a channel directly

Press the Channel Number buttons (0-9 and 100). To select channel 4, press “4” (or press “0”, “4”). To select channel 38, press “3”, “8”.

To select channel 125, press “100”, “2”, “5” in sequence.

If you cannot select certain channels, either TV (off the air) or CA- BLE channels

Check if the TV/CABLE function is properly set. See page 16.

Selecting the video input source

You can use the TV/VIDEO button to view signal coming from other devices, such as VCR's or video disc players that may be connected to your TV. (See “Connecting Your TV” on page 5.)

Note: To operate your TV and video equipment properly, refer to the instructions furnished with the video equipment.

CH

VOL MENU/ VOL

ENTER

CH

TV

CABLE

VCR EXIT

FAV CH TV/VIDEO

A

REC TV/VCR STOP PLAY

STILL SOURCE PIP

SLOW PAUSE REW FF

PIP CH LOCATE SWAP

CHANNEL

s t

EXIT

TV/VIDEO

1 Turn the TV and the video equipment ON.

2 Press TV/VIDEO on the Remote Control or on the TV to select “VIDEO 1” or “VIDEO 2”.

The selected source will be displayed in purple.

3 Operate the video equipment normally.

About the Demonstration Mode

TV

VIDEO1

VIDEO2

TO SELECT PUSH TV/VIDEO

When this function is activated, your TV will automatically display a variety of its on-screen menus and special features. This function is provided for demonstration purposes only.

1	Press MENU, then s or t until “DEMO”
	in the Option menu is displayed in purple.	LANGUAGE:[ENGLISH]FRANCAIS
			ESPANOL
2	Press T or S to select “START”.	DEMO:	[START]STOP
		C.CAPT:	C1	C2	C3 C4 T1
			T2	T3	T4[OFF]

The on-screen demonstration will start after about 15 seconds.

Tostopthedemonstration

MOVE[t s] SELECT[T S]

Press EXIT or RECALL on the Remote or select “STOP” in the menu.

18