Preparation
Using the Remote with VCR or Cable TV Converter
●To control a TOSHIBA VCR, first set the TV/CABLE/VCR switch to “VCR” position. The buttons shown below will then control the VCR. The rest of the buttons operate the TV as usual.
If you have another brand of VCR, you can probably program your Remote to control it. Details are on page 11.
●To control a cable TV converter, this Remote Control must be programmed to recognize the brand of your converter. See page 11.
The shaded buttons can be used to control the cable TV converter.
Set the TV/CABLE/VCR switch to “CABLE” position whenever you control the cable TV converter.
Aim at the VCR or cable TV converter
Channel Number
Press the numbers desired for direct access.
TV/CABLE/VCR
“CABLE”: To control the cable box
“VCR”: To control the VCR
TV/VCR
Press to select the TV mode to view one program while recording another program.
REC (record)
Press to start recording.
SLOW
Press to view a
PAUSE
Press to freeze the picture during playback or recording.
Press again to release.
RECALL MUTE POWER
o
1 2 3
4 5 6
7 8 9
CH RTN
100 0 ENT
CH
VOL MENU/ VOL
ENTER
CH
TV
CABLE
VCR EXIT
FAV CH TV/VIDEO
A
REC TV/VCR STOP PLAY
STILL SOURCE PIP
SLOW PAUSE REW FF
PIP CH
LOCATE SWAP
POWER
Press the button to turn the VCR (or converter) on.
Press again to turn off.
ENTER
Some VCR's and Cable TV converters require “ENT” to change channel number.
CHANNEL s t
Press s to select next higher channel. Press t to select next lower channel.
STOP
Press to stop the tape.
PLAY
Press to begin tape playback.
FF(fast forward)
Press to rapidly advance the tape. In playback mode, press to view the picture moving rapidly in forward direction.
REW (rewind)
Press to rewind the tape.
In playback mode, press to view picture moving rapidly in reverse.
10