Toshiba 32AF45 appendix Programming the remote control to operate your other devices

To control a cable TV converter:

Program the remote control to recognize the brand of your converter (see “Programming the remote control to operate your other devices” below). The buttons shown at right will control the cable TV converter. Press the CABLE button first.

CABLE
	POWER	TV	VCR	CABLE
Power
				DVD
	1	2	3
				+10
Channel	4	5	6	100
Numbers	7	8	9	0
		CH +
	VOL	MENU/		VOL
	–			+
		ENTER
Channel +/–
		CH –
	EXIT	RECALL	TV/VIDEO	FAV
CH Enter	VOL		CH RTN	FAV
	RESET	CAP/TEXT	1/2	16:9
	DISPLAY	DVD CLEAR	TOP MENU	DVD MENU
	CODE	MTS	SLEEP	MUTE
	REW	PLAY		FF
	TV/VCR STOP PAUSE/STILL
	REC		VCR CH
			DVD SKIP

Using the Remote Control

Programming the remote control to operate your other devices

This remote control is pre-programmed to operate Toshiba VCRs and DVD players. To control VCRs, DVD players, or cable converters other than Toshiba models, you must follow the steps below to program your remote control.

1.While holding down the CODE button, press the button for the device you want to control (VCR, DVD, or CABLE).

2.Enter the 2-digit code listed on page 13 using the Number buttons (0–9) within 10 seconds.

3.Point the remote control at the VCR, DVD player, or converter and press POWER to test the code.

If the VCR, DVD player, or converter turns on, you have entered the right code.

If the VCR, DVD player, or converter does not respond to the remote control, you may have entered the wrong code. Repeat steps 1 and 2 using another code.

For future reference, write down the codes you used:

VCR code ________________________

DVD player code ___________________

Cable TV converter code ____________

12

POWER			VCR
	TV	VCR	CABLE
			CABLE
			DVD
1	2	3	DVD
			+10
4	5	6	100
7	8	9	0
	CH +
VOL	MENU/		VOL
–			+
	ENTER
	CH –
EXIT	RECALL	TV/VIDEO	FAV
VOL		CH RTN	FAV
RESET	CAP/TEXT	1/2	16:9
DISPLAY	DVD CLEAR	TOP MENU	DVD MENU
CODE	MTS	SLEEP	MUTE
REW	PLAY		Code
			FF

Notes:

•When shipped from the factory, the remote control is set to operate your TV.

•If you do not enter the code within 10 seconds from step 1 or if you enter a code not listed below, this operation is canceled.

•Each time you replace the batteries, you must reprogram the remote control.

•Some newer VCRs are capable of working on either of two remote codes. These VCRs have a switch labeled “VCR1/VCR2.”

If your VCR has this kind of switch and does not respond to any of the codes for your VCR, set the switch to the other position (VCR1 or VCR2) and reprogram the remote control.

J3S90121A(E)_P07-16 12 9/03/2005, 5:57 PM