Toshiba 40RF350U manual Selecting the color temperature, Using CableClear digital noise reduction

Chapter 7: Using the TV’s advanced features

Selecting the color temperature

You can change the quality of the picture by selecting from three preset color temperatures (Cool, Medium, and Warm), as described below.

Mode Picture Quality

Cool blueish

Medium neutral

Warm reddish

To select the color temperature:

1 Press Yand open the Video menu.

2 Highlight Picture Settings and press T.

3 Highlight Advanced Picture Settings and press T.

4 Highlight Color Temperature and press T.

Advanced Picture Settings				Mode: Preference
	Dynamic Contrast			High
	Static Gamma		0
	Color Temperature			Cool
		Reset		Done

5 In the Color Temperature field, select the mode you prefer (Cool, Medium, or Warm).

Color Temperature			Mode: Preference
	Color Temperature		Cool
	B Drive	0
	G Drive	0

ResetDone

6 Press B or b to select either B Drive or G Drive, and then press C or c to adjust the settings.

B Drive	1
G Drive	1

•B Drive: c makes the picture blueish.

•G Drive: c makes the picture greenish.

Note: The B Drive and G Drive settings are connected to the Color Temperature settings and will change based on which setting is selected in step 5 above.

7 To save the new settings, highlight Done and press T. To revert to the factory defaults, highlight Reset and press T.

Note: If you select one of the factory-set picture modes (Sports, Standard, Movie, or Document) and then change the color temperature mode, the picture mode automatically changes to Preference.

Using CableClear® digital noise reduction

The CableClear® digital noise reduction feature allows you to reduce visible interference in your TV picture. This may be useful when receiving a broadcast with a weak signal (especially a Cable channel) or playing a noisy video cassette or disc.

To change the CableClear settings:

1 Press Yand open the Video menu.

2 Highlight Noise Reduction and press T.

Video

Mode	Sports
Picture Settings
Noise Reduction
ColorMaster
xvYCC Selection	Auto
Game Mode	Off
Theater Settings
TheaterLock	Off

3 In the CableClear field, select your desired setting.

Noise Reduction				ANT
	CableClear		Auto
	MPEG Noise Reduction		Low
		Reset	Done

Note:

•If the current input is ANT, VIDEO 1, or VIDEO 2, the menu will display the text “CableClear.” The available selections are Off, Auto, Low, Middle, and High.

•If the current input is ColorStream HD1, ColorStream HD2, HDMI 1, HDMI 2, or HDMI 3, the menu will display the text “DNR.” The available selections are Off, Auto, Low, Middle, and High. Auto will react proportionally to the strength of the noise. Low, Middle, and High will reduce the noise in varying degrees, from lowest to highest, respectively.

4 To save the new settings, highlight Done and press T. To revert to the factory defaults, highlight Reset and press T.

71