33
HL196 (E/F) Web 213:276
Chapter 5: Using the TV’s features

To tune to a channel or input in Select mode:

1While watching TV, press 3 C or # c to open the
Channel Browser™ banner and surf back to a previous
item or surf forward to the next item in the list.
In Select mode, when you stop on an item in the browser
banner, it will be highlighted but you must press T to
tune the TV to the highlighted item.
2Press O to close the Channel Browser™ banner.

Adding and clearing channels and inputs in the

channel history

Adding channels and inputs to the channel history:

As a channel or input is tuned, the Channel Browser™ adds it
to the History and displays it on the “right side” of the Browser
banner. Previously tuned channels/inputs are “shifted” to the
left, eventually moving off the left side of the Browser banner.
Press 3 C to surf backward through the previously tuned
channels/inputs. Any channel or input that is tuned repeatedly
will not be repeated in the History, but instead is moved to the
end of the list on the right side of the Browser banner.
The Channel Browser™ will store the following channels:
•All channels that are tuned using the numeric buttons on the
remote control.
•All channels that are tuned using < or , on the remote
control for at last 5 second.
•All inputs that are tuned for at least 5 seconds.
Note: Whenever an item is selected that cannot be tuned (for
various reasons), the TV will automatically tune to the
previously viewed channel or input.

Clearing channels from the channel history

•Reconfiguring the ANT 1 or ANT 2 input will clear the
channel history.
Note: See page 24 for details on configuring the antenna
inputs.
•Removing the CableCARD™ will clear the channel history.
•Once 32 channels or inputs are stored in the history list, the
oldest item will be removed from the list when a new
channel or input is tuned.
•If History List in the Channel Browser Setup is set to
“Power Off Clear (On),” turning off the TV will clear the
channel History.
Tuning to the next programmed channel

To tune to the next programmed channel:

Press < or , on the remote control or TV control panel.
Note: This feature will not work unless you program channels
into the TV’s channel memory (- page 25).
Tuning to a specific channel (programmed or unprogrammed)

Tuning analog channels:

Press the Channel Number buttons (0–9) on the remote
control. For example, to select channel 125, press 1, 2, 5.

Tuning digital channels:

Press the Channel Number (0–9) on the remote control,
followed by the dash (=) and then the sub-channel number.
For example, to select digital channel 125-1, press 1, 2, 5, –, 1.
Note: If a digital channel is not programmed—either through
the automatic channel scan (- page 25) or the channel add/
delete function (- page 26)—you will have to tune the RF
channel using the Channel Numbers and dash (=) on the
remote control.
Inputs
Channel Browser
ANT 1 CABLE 4 AAA 480i
ClrStrmHD1
Satellite..
__ __
1ANT 1
ClrStrmHD2
Video 2
HDMI 1
HL196_EN.book Page 33 Friday, June 2, 2006 2:35 PM