Toshiba 50A11 Adjusting the color convergence

Adjusting the color convergence

This projection TV uses three separate TV tubes: red, green, and blue. The red, green, and blue images are projected onto the screen where they converge to form a full-color picture. You can see a clear picture

RECALL MUTE

POWER

Setting up your TV

only when the three images converge correctly. Convergence may drift over time or if the TV is moved. If you can see clear images on the screen, skip this procedure.

Make this adjustment after the TV has been on for at least 30 minutes.

To check and adjust the color convergence:

1.Press MENU, then press x or • until the PICTURE menu appears.

2.Press y or z to highlight CONVERGENCE (see illustration below left).

3.Press x or • to display the center CONVERGENCE menu (see illustration below right).

		P I CTURE ANTENNA
MODE			SPORTS
FLESH TONE			ON
NO I SE REDUCTION			OFF
COLOR			COOL	RED	BLUE
	TEMPERATURE			ENTER : TO SELECT COLOR
CONVERGENCE
SAVE NEW PREFERENCE				EX I T : TO SELECT POS I T I ON

If you see separate red, blue, or green crossed lines (or red or blue shadows next to white lines), you need to adjust the convergence.

4.Press ENTER to highlight RED or BLUE, depending on which color needs adjusting. If both red and blue need adjusting, perform steps 4 and 5 twice.

5.Press y (up), z (down), x (left), or • (right) on the remote control to converge the red or blue line into the green line, which will turn completely white when correctly adjusted. When color convergence is correctly adjusted, you will see two single white lines.

6.Press EXIT to close the center CONVERGENCE menu and open the circumference CONVERGENCE menu (see illustration below left).

7.Press the corresponding Number button (1–4 and 6–9) to select the area to adjust.

8.Press ENTER to highlight RED or BLUE (see illustration below right), depending on which color needs adjusting. If both red and blue need adjusting in the selected area, perform steps 8 and 9

twice.

3

	1														2														3
	4																												6
		PUSH					1 – 9
																																	RED	BLUE
																																	ENTER : TO SELECT COLOR
	7														8														9
																																	EX I T : TO SELECT POS I T I ON
																																33
1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16	17	18	19	20	21	22	23	24	25	26	27	28	29	30	31	32

9.Press yzx • to converge the red or blue line into the green line, which will turn completely white when correctly adjusted. Repeat steps 8 and 9 until you see two single crossed white lines.

10.Press EXIT once to select another area to adjust, and then repeat steps 7–9.

11.Press EXIT twice to close the CONVERGENCE menu.

1 2 3

4 5 6

7	8	9
		CH RTN
100	0	ENT
	CH
VOL	MENU/	VOL
	ENTER
	CH
TV
CABLE	EXIT
VCR
	FAV CH	TV/VIDEO

Number

MENU/

ENTER

yzx •

EXIT

20