BP7315 Florissant 3/7/06 8:42 AM Page 6
!WARNING
Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.
CAUTION: To reduce the risk of electrical shock, disconnect the electrical supply circuit before installing the fan, light kit or receiver.
NOTE: Make all wiring connections using wire connectors (supplied). Make sure that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire.
5. Refer to Figures 5 and 6 and connect the receiver wires to the supply wires and the fan motor wires as follows:
a.Securely connect the green grounding wire from the motor bracket to the supply grounding conductor (this may be a bare wire or a wire with green insulation).
b. Securely connect the supply white (neutral) wire to the receiver white (AC IN N) wire.
c.Securely connect the supply black wire (hot) wire to the receiver black (AC IN
L)wire.
d.Securely connect the fan motor white wire to the receiver white (TO MOTOR
N)wire.
e.Securely connect the fan motor black wire to the receiver red (TO MOTOR L) wire.
f.Securely connect the fan motor blue wire to the receiver blue (FOR LIGHT) wire.
!WARNING
Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.
FAN BLACK
WIRE
L | N |
| |
MOTOR | MOTOR | LIGHT | |
TO | |||
TO | FOR | ||
|
|
RECEIVER
RED WIRE
RECEIVER AND
MOTOR WHITE WIRES
RECEIVER AND
MOTOR BLUE
WIRES
GREEN WIRE
FROM MOTOR BRACKET
GROUND WIRE
RECEIVER
L
IN
AC
N
IN
AC
SUPPLY WHITE (NEUTRAL) AND RECEIVER WHITE WIRES
SUPPLY BLACK (HOT) AND RECEIVER BLACK WIRES
Figure 5
6
