Emerson CF730 warranty Unpacking Instructions, Materials

BP7315 Florissant 3/7/06 8:42 AM Page 3

This Manual is Designed to Make it as Easy as Possible for You to

Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver One 1/4” blade screwdriver

One 7/16” box or open end wrench or ratchet wrench

One wire stripper One stepladder

Three wire connectors (supplied)

Materials

Wiring, outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following sizes:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

!WARNING

Before assembling your ceiling fan, refer to section on proper method of wiring your fan (page 5). If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

!WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

1. Open styrofoam unit containing fan. Remove top half of styrofoam unit. Remove parts and check to see that you have received the following parts:

a. Fan housing

b. One mounting plate c. One motor assembly d. Five fan blades

e. Five blade flanges with captive screws

f. One light fitter assembly g. One lower glass

h. One SW101 Fan/Light Wall Control (transmitter and receiver)

3

i.One loose pars bag containing:

1.Sixteen M5 x 6mm washer head screws

2.Five M5 x 12mm pan head screws with lockwashers

3.One M6 x 14mm pan head screw with lockwasher (extra flange-to-motor hub screw/ lockwasher)

4.Four 1/4-20 hex locknuts

5.Four 1/4” flat washers

6.Three wire connectors

7.One receiver bracket

8.One pull chain pendant

9.One coupling

B

A

C

D

E F

G

H

I

EMERSON

NOTE: If you are uncertain of part description, refer to exploded view.