BP7315 Florissant 3/7/06 8:42 AM Page 5
2. Swing the receiver bracket down over 
the receiver (Figure 1). Position the receiver so that the code switch is not covered by the bracket, then securely reinstall the pan head screw with lockwasher (previously removed).
3.Pass the outlet box supply wires (black, white and ground) through the center hole in the mounting plate and securely attach the mounting plate to the outlet box using the screws supplied with the outlet box (Figure 3).
MOUNTING | PAN HEAD SCREW |
WITH LOCKWASHER | |
PLATE |
|
CODE | RECEIVER |
SWITCH |
|
RECEIVER
BRACKET
Figure 1
!WARNING
The fan must be hung with at least 7' of clearance from floor to blades (Figure 2).
NOTE: In order for the fan housing to fit flush with the ceiling, the outlet box must not protrude below the ceiling.
OUTLET BOX
| MOUNTING |
SCREWS (SUPPLIED | PLATE |
WITH OUTLET BOX) |
|
Figure 3
CEILING
4. Carefully lift the fan motor assembly and engage the slot in the motor bracket with the hook on the mounting plate so that it is securely suspended (Figure 4).
AT LEAST
7'
FLOOR
Figure 2
!WARNING
The outlet box and joist must be securely mounted and capable of supporting at least 50 lbs. Use only a U.L. outlet box listed as “Acceptable for Fan Support”.
MOUNTING PLATE
HOOK
MOTOR
BRACKET
FAN MOTOR
ASSEMBLY
Figure 4
!WARNING
To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked “Acceptable for Fan Support”, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt.
If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician.
5
